|
|
|
22
Procedure to Correct a Twisted Safety
Shoulder Belt at the “D” Ring (if so
equipped) Front and/or Rear Outboard
Seating Positions
NOTE:
The restraint system shown in the
following figures may be different than
the restraint system in your vehicle.
However, use these figures and this
procedure to correct a twisted safety
shoulder belt at any outboard seating
position that has a “D” ring.
23
1.
Grasp the belt webbing at the “D” ring. See
Figure 2.
2.
Rotate and fold the belt webbing over itself
as required to remove the twist.
3.
Feed the folded portion of the belt through
the “D” ring.
4.
When completed, the safety belt should look
like Figure 3.
24
Safety Belt Extension Assembly
For some people, the safety belt may be too
short even when it is fully extended. You can
add about eight inches (20 cm) to the belt length
with a safety belt extension assembly (part
number 611C22). Safety belt extensions are
available at no cost from your dealer.
Use only extensions manufactured by the same
supplier as the safety belt. Manufacturer
identification is located at the end of the webbing
on the label. Also, use the safety belt extension
only if the safety belt is too short for you when
fully extended. Do not use extension to change the
fit of the shoulder belt across the torso.
R
WARNING
Failure to follow these instructions will
affect the performance of the safety belts
and increase the risk of personal injury.
25
Safety Belt Maintenance
Check your safety belt system periodically to
make sure that it works properly and isn’t
damaged. If the webbing shows any wear, nicks
or cuts, have it examined by a qualified
technician to determine if replacement is
necessary. Always have your safety belt system
checked after a collision by a qualified
technician.
All safety belt assemblies, including retractors,
buckles, front seat belt buckle support assemblies
(slide bar) (if so equipped), child safety seat
tether bracket assemblies (if so equipped), and
attaching hardware, should be inspected after
any collision. Ford recommends that all safety
belt assemblies used in vehicles involved in a
collision be replaced. However, if the collision
was minor and a qualified technician finds that
the belts do not show damage and continue to
operate properly, they do not need to be
replaced. Safety belt assemblies not in use
during a collision should also be inspected and
replaced if either damage or improper operation
is noted.
Cleaning the Safety Belts
Clean the safety belts with any mild soap
solution that is recommended for cleaning
upholstery or carpets. Do not bleach or dye the
belt webbing because this may weaken it.
Air Bag Supplemental Restraint
System (SRS)
Driver air bag
Your vehicle is equipped with a driver side air
bag supplemental restraint system located in the
steering wheel and identified by the letters
“SRS” in the center of the wheel.
|
|
|