|
|
P0135-O2 SENSOR 1/1 HEATER PERFORMANCE (CONTINUED) 4. (Z42) O2 1/1 HEATER GROUND CIRCUIT OPEN Measure the resistance between ground and the (Z42) O2 1/1 Heater Is the resistance below 0.5 of an ohm? Yes >> Go To 5 No >> Repair the excessive resistance in the (Z42) O2 1/1 Heater ground circuit. Perform the POWERTRAIN VERIFICATION TEST. (Refer 5. PCM NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal Were there any problems found? Yes >> Repair as necessary. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) No >> Replace and program the Powertrain Control Module per Service Information. Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE) 9 - 174 ENGINE - ELECTRICAL DIAGNOSTICS - 3.7L/4.7L/5.7L DR/DH |