|
|
ACM MESSAGES NOT RECEIVED For a complete wiring diagram Refer to Section 8W. • When Monitored: • Set Condition: Possible Causes BUS MESSAGE NOT RECEIVED DTC PRESENT INSTRUMENT CLUSTER 1. BUS MESSAGE NOT RECEIVED DTC PRESENT With the DRBIII T , attempt to communicate with the module that corresponds to the DTC that is set. Was the DRBIII T able to I/D or communicate with the Module in question? Yes >> Go To 2 No >> Refer to Communication category for the related symptom(s). Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST - VER 1.) 2. INSTRUMENT CLUSTER NOTE: If this is an active DTC, answer yes to the question. T , erase DTCs. Cycle the ignition, wait approximately 1 minute. With the DRBIII T , read DTCs. Did the DTC reset? Yes >> Replace the Instrument Cluster in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST - VER 1.) No >> The condition is not present at this time. Monitor DRBIII T parameters while wiggling the related wire harness. Refer to any Technical Service Bulletins (TSB) that may apply. Visually inspect the related wir- Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST - VER 1.) 8J - 32 INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS DR/DH |