TEST
ACTION
APPLICABILITY
8
Turn the ignition off.
Disconnect the Transmission Solenoid Assembly harness connector.
Disconnect the PCM C2 harness connector.
Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the governor pressure sensor signal circuit in the Transmis-
sion Solenoid Assembly harness connector.
Is the voltage above 1.0 volt?
All
Yes
→
Repair the governor pressure sensor signal circuit for a short to
voltage.
Perform TRANSMISSION VERIFICATION TEST VER - 1.
No
→
Go To
9
9
Turn the ignition off.
Disconnect the Transmission Solenoid Assembly harness connector.
Remove the transmission oil pan.
Disconnect the Governor Pressure/Transmission Temperature Sensor harness con-
nector.
Measure the resistance of the 5 volt supply circuit between the Governor Pressure/
Transmission Temperature Sensor harness connector and the Transmission Solenoid
Assembly harness connector.
Is the resistance below 5.0 ohms?
All
Yes
→
Go To
10
No
→
Replace the Transmission Solenoid Assembly in accordance with
the Service Information.
Perform TRANSMISSION VERIFICATION TEST VER - 1.
10
Turn the ignition off.
Disconnect the Transmission Solenoid Assembly harness connector.
Remove the transmission oil pan.
Disconnect the Governor Pressure/Transmission Temperature Sensor harness con-
nector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the governor pressure sensor signal circuit between the
Transmission Solenoid Assembly harness connector and the Governor Pressure/
Transmission Temperature Sensor harness connector.
Is the resistance below 5.0 ohms?
All
Yes
→
Go To
11
No
→
Replace the Transmission Solenoid Assembly in accordance with
the Service Information.
Perform TRANSMISSION VERIFICATION TEST VER - 1.
332
TRANSMISSION
P1763-GOVERNOR PRESSURE SENSOR VOLTS TOO HI —
Continued