|
|
(M) Malfunction Indicator Lamp (MIL) illuminated during engine operation if this DTC was recorded (depending if required by CARB and/or EPA). MIL is displayed as an engine icon on instrument panel. (G) Generator lamp illuminated Generic Scan Tool P-Code DRB Scan Tool Display Brief Description of DTC P0500 (M) No Vehicle Speed Sensor Signal No vehicle speed sensor signal detected during road load conditions. P0500 (M) No Vehicle Speed Sensor Signal A vehicle speed signal was not detected. P0505 (M) Idle Air Control Motor Circuits SBEC II P0522 Oil Pressure Voltage Too Low Oil pressure sending unit (sensor) voltage input below the minimum acceptable voltage. P0523 Oil Pressure Voltage Too High Oil pressure sending unit (sensor) voltage input above the maximum acceptable voltage. P0524 Oil Pressure Too Low Engine oil pressure is low. Engine power derated. P0545 A/C Clutch Relay Circuit Problem detected in air conditioning clutch relay control circuit. P0551 Power Steering Switch Failure Incorrect input state detected for the power steering switch circuit. PL: High pressure seen at high speed. P0562 Charging System Voltage Too Low Supply voltage sensed at ECM too low. P0563 Charging System Voltage Too High Supply voltage sensed at ECM too high. P0600 PCM Failure SPI Communications No communication detected between co-processors in the control module. P0601 (M) Internal Controller Failure Internal control module fault condition (check sum) detected. P0602 (M) ECM Fueling Calibration Error ECM Internal fault condition detected. P0604 RAM Check Failure Transmission control module RAM self test fault detected. -Aisin transmission P0605 ROM Check Falure Transmission control module ROM self test fault detected -Aisin transmission P0606 (M) ECM Failure ECM Internal fault condition detected. P0615 Starter Relay Control Circuit An open or shorted condition detected in the starter relay control circuit. P0622 (G) Generator Field Not Switching Properly An open or shorted condition detected in the generator field control circuit. P0645 A/C Clutch Relay Circuit An open or shorted condition detected in the A/C clutch relay control circuit. P0700 EATX Controller DTC Present This SBEC III or JTEC DTC indicates that the EATX or Aisin controller has an active fault and has illuminated the MIL via a CCD (EATX) or SCI (Aisin) message. The specific fault must be acquired from the EATX via CCD or from the Aisin via ISO-9141. P0703 Brake Switch Stuck Pressed or Released Incorrect input state detected in the brake switch circuit. (Changed from P1595) P0711 (M) Trans Temp Sensor, No Temp Rise After Start Relationship between the transmission temperature and overdrive operation and/or TCC operation indicates a failure of the Transmission Temperature Sensor. OBD II Rationality. Was MIL code 37. 25 - 8 EMISSIONS CONTROL AN EMISSIONS CONTROL (Continued) |