|
|
1 CAB TILTING MECHANISM Disassembly and assembly 5-6 9. Slide the piston (3) over the piston rod until 10. Fit the circlip (1) onto the piston rod, using an axle spring clip pliers (outer circlip 11. Tap the brass upper bearing approx. 5 mm into the cylinder (past the circlip groove) 12. Press the piston rod into the cylinder. 13. Fit the circlip (12) into the cylinder. Pull the piston rod fully out to check whether the 14. Apply a thin film of oil to the piston rod and the inside of the cylinder. 15. Turn the cylinder upside down and press the piston rod into the cylinder using the 16. Press the piston rod out of the cylinder and pressurise the cylinder. Inspect the latter for 17. Tap the dirt scraper (11) evenly into the cylinder using a plastic or copper hammer. 18. Attach the lifting cylinder underneath the cab and check its operation. 1 2 3 4 5 6 7 8 9 10 11 12 13 A A C B K1 01 346 6 ᓻ 0209 |