|
|
NOTE: • If the indicator light stays on constantly, programming is complete and the garage door/device should acti- • To program the two remaining HomeLink buttons, repeat each step for each remaining button. DO NOT If you unplugged the garage door opener/device for Reprogramming A Single HomeLink Button (Canadian/ To reprogram a channel that has been previously trained, 1. Cycle the ignition to the ON/RUN position. 2. Press and hold the desired HomeLink button until the indicator light begins to flash after 20 seconds. Do not 3. Without releasing the button, proceed with “Canadian/ Gate Operator Programming” step 2 and follow all Using HomeLink To operate, push and release the programmed HomeLink Security It is advised to erase all channels before you sell or turn in To do this, push and hold the two outside buttons for 20 The HomeLink Universal Transceiver is disabled when the Troubleshooting Tips If you are having trouble programming HomeLink, here held transmitter. 3 GETTING TO KNOW YOUR VEHICLE 105 |