|
|
Place the handheld transmitter 1 to 3 in (3 to 8 cm) away 威 button you wish to program while keeping the indicator light in view. 3. Simultaneously press and hold both the chosen 威 button and the handheld transmitter button until the HomeLink 威 indicator changes from a slow to a rapidly blinking light, then release both the HomeLink 威 and handheld transmitter buttons. Watch for the HomeLink 威 indicator to change flash rates. When it changes, it is programmed. It may take up to NOTE: • Some gate operators and garage door openers may require you to replace Step 3 with procedures noted in • After training a HomeLink威 channel, if the garage door does not operate with HomeLink 威 and the ga- rage door opener was manufactured after 1995, the 4. Press and hold the just-trained HomeLink 威 button and observe the indicator light. If the indicator light stays on constantly, programming is 威 button is pressed. If the indicator light blinks rapidly for two seconds and 5. Programming A Rolling Code System 140 UNDERSTANDING THE FEATURES OF YOUR VEHICLE |