Index Chrysler Chrysler TOWN & COUNTRY, VOYAGER, Dodge Caravan - service repair manual 2001-2007 year
|
|
DIODE REMOVAL (1) Disconnect the battery. the protective covering. (3) Remove the diode from the harness, pay atten- tion to the current flow direction (Fig. 13). INSTALLATION (1) Remove the insulation from the wires in the harness. Only remove enough insulation to solder in (2) Install the new diode in the harness, making sure current flow is correct. If necessary, refer to the (3) Solder the connection together using rosin core type solder only. Do not use acid core solder. (4) Tape the diode to the harness using electrical tape. Make sure the diode is completely sealed from (5) Re-connect the battery and test affected sys- tems. TERMINAL REMOVAL (1) Follow steps for removing terminals described in the connector removal section. (2) Cut the wire 6 inches from the back of the con- nector. INSTALLATION (1) Select a wire from the terminal repair kit that best matches the color and gage of the wire being (2) Cut the repair wire to the proper length and remove one–half (1/2) inch of insulation. (3) Splice the repair wire to the wire harness (see wire splicing procedure). (4) Insert the repaired wire into the connector. and reconnect the connector to its mating half/compo- (6) Re-tape the wire harness starting at 1–1/2 inches behind the connector and 2 inches past the (7) Connect battery and test all affected systems. Fig. 13 DIODE IDENTIFICATION 1 - CURRENT FLOW 8W - 01 - 14 8W-01 WIRING DIAGRAM INFORMATION RS |