TEST
ACTION
APPLICABILITY
1
Turn the ignition on.
NOTE: Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
All
ACM - ACTIVE DTC
Go To
2
ACM - STORED DTC
Go To
9
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the Right Front Impact Sensor connector.
Disconnect the Airbag Control Module connector.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION ON, THEN RECONNECT THE BATTERY.
Measure the voltage of the right Front Impact Sensor Signal circuit and sensor
ground at the Right Front Impact Sensor connector.
Is there any voltage present?
All
Yes
→ Repair the Right Front Impact Sensor 1 Signal circuit shorted to
battery.
Perform __AIRBAG VERIFICATION TEST - VER 1.
No
→ Go To 3
3
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
ON, THEN RECONNECT THE BATTERY.
Measure the resistance of the Right Front Impact Sensor Signal circuit between the
Right Front Impact Sensor connector and ground.
Is the resistance below 2.0L ohms?
All
Yes
→ Repair the Right Front Sense signal circuit shorted for a short to
ground.
Perform __AIRBAG VERIFICATION TEST - VER 1.
No
→ Go To 4
4
Measure the resistance between the Right Front Impact Sensor 1 Signal and Sensor
Ground circuits at the Right Front Impact Sensor 1 connector.
Is the resistance below 100K ohms?
All
Yes
→ Repair the Right Front Impact Sensor circuits shorted together.
Perform __AIRBAG VERIFICATION TEST - VER 1.
No
→ Go To 5
185
AIRBAG
NO RIGHT FRONT IMPACT SENSOR COMMUNICATION —
Continued