TEST
ACTION
APPLICABILITY
5
Turn the ignition off.
Disconnect the O2 Sensor harness connector
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the O2 Sensor Signal circuit from the O2 Sensor harness
connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
All
Yes
→ Go To 6
No
→ Repair the open O2 Sensor Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
6
Turn the ignition off.
Disconnect the O2 Sensor harness connector
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the O2 Sensor Return circuit from the O2 Sensor harness
connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
All
Yes
→ NOTE: Before continuing, check the PCM harness connector
terminals for corrosion, damage, or terminal push out. Repair as
necessary. Replace and program the Powertrain Control Module
in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Repair the open O2 Sensor Return circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
322
DRIVEABILITY - NGC
P0132-O2 SENSOR 1/1 VOLTAGE HIGH —
Continued