|
|
|
2. Remove the second protective cap insert a hand
inside the opening.
3. Rotate clockwise to remove the bulb holder remove
the bulb from the bulb holder.
4. Install the bulb by pressing it into bulb holder then
turn install the bulb holder and turn it counterclock-
wise.
5. Install the previously removed protective caps.
Tail Lights/Brake Lights
These are LEDs. For the replacement, contact an autho-
rized dealer.
Reversing Light
WARNING!
The reverse lights are located close to the exhaust
pipes; take the utmost care not to get burnt during
the bulb replacement.
To replace the reversing lights, turn the bulb holder
counterclockwise, remove the bulb and replace it.
Second Protective Cap
7
IN CASE OF EMERGENCY
173
Rear Of Vehicle
1 — Reverse Light Location
2 — Reverse Light Location
Reversing Light Bulb Holder
174
IN CASE OF EMERGENCY
Third Brake Lights
These are LEDs. For the replacement, contact an autho-
rized dealer.
License Plate Lights
To replace the bulbs proceed as follows:
1. Compress the retaining clip, then pull the license
plate light cluster out.
2. Turn bulb holder counterclockwise, remove bulb and
replace it.
License Plate Lamp Removal
1 — Bulb Holder
2 — Bulb
7
IN CASE OF EMERGENCY
175
Roof Light
To change the bulb, proceed as follows:
1. Remove roof light working at the points indicated by
the arrows.
2. Open protective flap (2) and replace bulb (1), releas-
ing it from the side contacts. Make sure that the new
bulb is correctly secured between the contacts.
3. Close protective flap (2) and install roof light in its
housing, making sure that it is locked in place.
Luggage Compartment Roof Light
To replace the bulb, proceed as follows:
1. Open the luggage compartment and remove luggage
compartment roof light, working in the direction
shown by the arrow.
Roof Light
1 — Bulb
2 — Protective Flap
176
IN CASE OF EMERGENCY
|
|
|