|
|
3. Install the stabilizer link (A) on the stabilizer bar (B) and stabilizer link bracket (C) with the joint pins set at the center of each moving range. See Fig. 30 . 4. Install the self-locking nut and flange nut, and lightly tighten them. 5. Place a jack under the knuckle, and raise the suspension to load the vehicle weight. 6. Tighten the self-locking nut (A) and flange nut (B) to specification while holding the respective joint pins (C) with a hex wrench. See TORQUE SPECIFICATIONS . See Fig. 29 . 7. After 5 minutes of driving, tighten the self-locking nut again to specification. NOTE: Use a new self-locking nut on assembly.
2004 Acura TSX 2004 SUSPENSION Rear - TSX
|