Acura TSX / Honda Accord CL. Manual - part 741

Fig. 114: Installing The Spring, Rack Guide Screw & Locknut 

74. Apply NEW sealant (Three Bond 1215 or Loctite 5699) to middle of the threads on the rack guide screw 

(B), then install the spring (C) and rack guide screw.  

75. Tighten the rack guide screw, and loosely install the locknut (D).  

76. Adjust the rack guide screw (see RACK GUIDE ADJUSTMENT ). After adjusting, check that the rack 

moves smoothly by sliding it right and left.  

77. Install a NEW stop rubber (A) and a NEW lock washer (B). Align the lock washer tabs (D) with the slots 

(E) on the rack end (C) while holding the lock washer in place. Repeat this step for the other side of the 
rack. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 115: Installing A NEW Stop Rubber & A NEW Lock Washer 

78. Hold the flat surface sections of the steering rack with a wrench, and tighten both rack ends. Be careful 

not to damages the rack surface with the wrench.  

79. Bend the lock washer (A) back against the flat spots on the rack end joint housing. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 116: Bending The Lock Washer Back Against The Flat Spots On The Rack End Joint Housing 

80. Apply multipurpose grease to the circumference of the rack end joint housing (A). 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 117: Applying Multipurpose Grease To The Circumference Of The Rack End Joint Housing & 
Boot Grooves On The Rack Ends 

81. Apply a light coat of silicone grease to the boot grooves (B) on the rack ends.  

82. Center the steering rack within its stroke.  

83. Clean off the any grease or contamination from the boot installation grooves (A) around on the gearbox 

housing. Install the boots (B) on the rack ends with the tie-rod clips (C), and fit the boot end in the 
installation grooves in the housing properly. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX