Acura TSX / Honda Accord CL. Manual - part 718

Fig. 25: Pressing Pump Drive Shaft Into The Pump Housing 

22. Install the 40 mm snap ring (C) with its radiused edge facing out.  

23. Coat the NEW 23.8 mm O-ring (A) with the power steering fluid, then position it on the bottom (B) of 

the pump housing. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 26: Installing The NEW 23.8 mm O-Ring 

24. Coat the NEW cover seals (A) and (B) with the power steering fluid, then position them into the grooves 

on the cover (C). 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 27: Installing The NEW Cover Seals 

25. Install the outer case (A) by aligning the slot (B) inside the outer case with the cover roll pin hole (C). Be 

sure that the slit (D) on the outer case is to direction shown. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX

  

 

Fig. 28: Installing The Outer Case 

26. Apply the power steering fluid to the rubber seal (E) (black), and install it in the slot (F) of the outer case. 

27. Apply power steering fluid to the slipper seal (G) (white), and install it on top of the rubber seal you just 

installed.  

28. Install the cam ring (A) with the "." mark (B) facing up. Align the slot (C) with the slot (D) in the outer 

case. 

 

2004 Acura TSX 

2004 STEERING Power Steering System - TSX