Acura TSX / Honda Accord CL. Manual - part 679

Fig. 127: Attaching The Heater Valve Cable 

COMPRESSOR REPLACEMENT 

1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work 

for a few minutes, then shut the engine off.  

2. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the 

frequencies for the radio's preset buttons.  

3. Disconnect the negative cable from the battery.  

4. Recover the refrigerant with a recovery/recycling/charging station (see REFRIGERANT 

RECOVERY ).  

5. Remove the drive belt (see DRIVE BELT ).  

6. Remove the compressor clutch connector (A) from the condenser fan shroud (B). Disconnect the 

condenser fan connector (C), then remove the wire harness clip (D) from the condenser fan shroud. 

 

2004 Acura TSX 

2004 AUTOMATIC A/C SYSTEMS Climate Control System - TSX

  

 

Remove the hose (E) from the reserve tank (F). Remove the bolts and the radiator fan shroud. Be careful 
not to damage the radiator fins when removing the condenser fan shroud. 

Fig. 128: Removing Radiator Fan Shroud 

7. Disconnect the compressor clutch connector (A). Remove the nuts, then disconnect the suction line (B) 

 

2004 Acura TSX 

2004 AUTOMATIC A/C SYSTEMS Climate Control System - TSX

  

 

and discharge line (C) from the compressor. Plug or cap the lines immediately after disconnecting them to 
avoid moisture and dust contamination. 

Fig. 129: Disconnecting The Suction Line & Discharge Line 

8. Remove the splash shield.  

9. Remove the mounting bolts and the compressor. Be careful not to damage the radiator fins when 

removing the compressor. 

 

2004 Acura TSX 

2004 AUTOMATIC A/C SYSTEMS Climate Control System - TSX

  

 

Fig. 130: Removing The Compressor 

10. Install the compressor in the reverse order of removal, and note these items: 

z

If you're installing a new compressor, you must calculate the amount of refrigerant oil to be 
removed from it (see A/C REFRIGERANT OIL REPLACEMENT ).  

z

Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before 
installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.  

z

Use refrigerant oil (KEIHIN SP-10) for HFC-134a KEIHIN piston type compressor only.  

z

To avoid contamination, do not return the oil to the container once dispensed, and never mix it with 
other refrigerant oils.  

z

Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture 
absorption.  

z

Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts 
the paint, wash it off immediately.  

z

Be careful not to damage the radiator fins when installing the compressor and the condenser fan 

 

2004 Acura TSX 

2004 AUTOMATIC A/C SYSTEMS Climate Control System - TSX