|
|
8. If the plastigage measures too wide or too narrow, remove the upper half of the bearing, install a new, complete bearing with the same color code(s), and recheck the clearance. Do not file, shim, or scrape the 9. If the plastigage shows the clearance is still incorrect, try the next larger or smaller bearing (the color listed above or below that one), and check clearance again. If the proper clearance cannot be obtained by Rod Bearing Selection 1. Inspect each connecting rod for cracks and heat damage. Connecting Rod Big End Bore Code Locations 2. Each rod has a tolerance range from 0 to 0.024 mm (0.0009 in.), in 0.006 mm (0.0002 in.) increments, depending on the size of its big end bore. It's then stamped with a number or bar (1, 2, 3 or 4/I, II, III, or Normal Bore Size: 51.0 mm (2.01 in.) NOTE: If you can't read the code because of an accumulation of oil and varnish,
2004 Acura TSX 2004 ENGINES 2.4L DOHC VTEC - TSX
|