Acura TSX / Honda Accord CL. Manual - part 429

Fig. 106: Removing The Cylinder Head Cover

CYLINDER HEAD REMOVAL 

1. Drain the engine coolant (see COOLANT REPLACEMENT ).  

2. Remove the drive belt (see DRIVE BELT ).  

3. Disconnect the intake air temperature (IAT) sensor connector (A). 

NOTE:

z

Use fender covers to avoid damaging painted surfaces.  

z

To avoid damage, unplug the wiring connectors carefully while holding the 
connector portion.  

z

To avoid damaging the cylinder head, wait until the engine coolant 
temperature drops below 100°F (38°C) before loosening the cylinder head 
bolts.  

z

Mark all wiring and hoses to avoid misconnection. Also, be sure that they 
do not contact other wiring or hoses, or interfere with other parts.  

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX

  

 

Fig. 107: Removing The Intake Air Duct 

4. Remove the vacuum hose (B) and breather pipe (C), then remove the intake air duct (D).  

5. Relieve fuel pressure (see FUEL PRESSURE RELIEVING ).  

6. Remove the quick-connect fitting cover (A), then disconnect the fuel feed hose (see FUEL 

LINE/QUICK-CONNECT FITTING REMOVAL ). 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX

  

 

Fig. 108: Removing The Quick-Connect Fitting Cover & Disconnecting The Fuel Feed Hose 

7. Remove the intake manifold (see REMOVAL ).  

8. Remove the exhaust manifold (see EXHAUST MANIFOLD REMOVAL & INSTALLATION ).  

9. Remove the bolt (A) securing the connecting pipe. 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX

  

 

Fig. 109: Removing The Bolt & The Water Bypass Hose 

10. Remove the water bypass hose (B).  

11. Remove the evaporative emission (EVAP) canister hose (A) and brake booster vacuum hose (B). 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX