Acura TSX / Honda Accord CL. Manual - part 266

Fig. 33: Pivoting Brake Caliper 
Courtesy of AMERICAN HONDA MOTOR CO., INC.

 

2004 Acura TSX 

2004 BRAKES Disc - TSX

  

 

 

2004 Acura TSX 

2004 BRAKES Disc - TSX

  

 

Fig. 34: Removing Pads & Pad Shims (Front)
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

Fig. 35: Identifying Pad Retainers (Front) 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

Brake Pad Inspection 

Check the thickness of the inner and outer pads. Do not include the thickness of the backing plate. If the brake 
thickness is less than the service limit, replace all the pads as a set. See DISC BRAKE SPECIFICATIONS . 

Disc Runout Inspection 

1. Inspect the disc surface for damage and cracks. Clean disc thoroughly, and remove all rust. Install 

suitable flat washers "A" and wheel lug nuts, and tighten the nuts to the specified torque to hold the brake 
disc securely against the hub. See DISC BRAKE SPECIFICATIONS . See Fig. 36 . 

 

2004 Acura TSX 

2004 BRAKES Disc - TSX

  

 

2. Set up the dial gauge against the brake disc and measure the runout at 0.4" (10 mm) from the outer edge 

of the disc. See DISC BRAKE SPECIFICATIONS . See Fig. 36 .  

3. If the disc runout is beyond the service limit, refinish the brake disc. 

Fig. 36: Measuring Runout Of Front Brake Disc 
Courtesy of AMERICAN HONDA MOTOR CO., INC. 

Disc Thickness & Parallelism Inspection 

1. Using a micrometer, measure disc thickness at 8 points, approximately 45 degrees apart and .4" (10 mm) 

in from the outer edge of the disc. See Fig. 37 . Replace the brake disc if the smallest measurement is less 
than the Minimum Thickness. See DISC BRAKE SPECIFICATIONS . 

NOTE:

Runout limit applies to front and rear discs.

NOTE:

If the brake disc is beyond the service limit for refinishing, replace it. A 
new disc should be refinished if its runout is greater than .004" (.10 mm).

 

2004 Acura TSX 

2004 BRAKES Disc - TSX