|
|
DTC TROUBLESHOOTING DTC B1125: DRIVER'S POWER WINDOW MOTOR A PULSE ERROR; DTC B1126: DRIVER'S 1. Open and close the driver's power window by using the driver's switch manually. 2. While the power window moving, select POWER WINDOWS from the HDS and enter the DATA LIST. 3. Check the EXIST/NONE information of the P/W PLSA (B1125) or P/W PLSB (B1126) in the DATA LIST. Do the information indicators display EXIST? YES: Replace the power window master switch. NO: Go to step 4. 4. Refer to the power window master switch input test, check for continuity between the driver's power window motor 6P connector and the power window master switch 23P connector (see MASTER Are all the wire harnesses OK? YES: Substitute a known-good power window master switch, and recheck. If DTC is gone, NO: Repair a short or an open in the wire. DTC B1140: DRIVER'S POWER WINDOW POSITION DETECT CIRCUIT ERROR 1. Clear the DTCs using the HDS. 2. Cycle the ignition switch to OFF and then back ON (II). 3. Open and close the driver's power window by using the driver's switch manually. 4. Check for DTCs using the HDS. Is DTC B1125 or B1126 indicated? YES: Troubleshoot the DTC B1125 or B1126 (see DTC B1125: DRIVER'S POWER NO: Go to step 5. 5. Do the power window control unit reset procedure (see RESETTING THE POWER WINDOW ). 6. Check for DTCs again using the HDS. Is DTC B1140 indicated? YES: Faulty door multiplex control unit; replace the power window master switch. NO: The system is recovered at this time.
2004 Acura TSX 2004 ACCESSORIES & EQUIPMENT Power Windows - TSX
|