Acura TSX / Honda Accord CL. Manual - part 239

1. Remove the driver's door switch trim (see FRONT DOOR PANEL REMOVAL/INSTALLATION ). 

Fig. 10: Removing The Driver's Door Switch Trim 

2. Disconnect the 13P connector (A) from the power mirror switch (B), and inspect the terminals. If OK, go 

to step 3.  

3. Choose the appropriate test based on the symptom: 

z

Both mirrors don't work, go to step 4.  

z

Left mirror doesn't work, go to step 6 .  

z

Right mirror doesn't work, go to step 7 .  

z

Defogger doesn't work (Canada), go to step 8 .  

Both Mirrors: 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Power Mirrors & Automatic Dimming Inside Mirror - TSX

  

 

4. Check for voltage between the No. 6 terminal and body ground with the ignition switch ON (II). There 

should be battery voltage. 

z

If there is no battery voltage, check for: 

„

blown No. 30 (7.5A) fuse in the under-dash fuse/relay box.  

„

an open in the BLK/YEL wire.  

z

If there is battery voltage, go to step 5.  

5. Check for continuity between the No. 3 terminal and body ground. There should be continuity. 

z

If there is no continuity, check for: 

„

an open in the BLK wire.  

„

poor ground (G 601).  

z

If there is continuity, check both mirrors individually.  

Left Mirror: 

6. Connect the No. 6 terminal to the No. 9 terminal, and the No. 2 (or No. 10) terminal to the No. 3 terminal 

with jumper wires. The left mirror should tilt down (or swing left) with the ignition switch ON (II). 

z

If the mirror does not tilt down (or does not swing left), check for an open in the BLU/WHT (or 
GRN/WHT) wire between the left mirror and the 13P connector. If the wire is OK, check the left 
mirror actuator.  

z

If the mirror neither tilts down nor swings left, repair the BLU/BLK wire.  

z

If the mirror works properly, check the mirror switch.  

Right Mirror: 

7. Connect the No. 6 terminal to the No. 7 terminal, and the No. 1 (or No. 10) terminal to the No. 3 terminal 

with jumper wires. The right mirror should tilt down (or swing left) with the ignition switch ON (II). 

z

If the mirror does not tilt down (or does not swing left), check for an open in the WHT/RED (or 
GRN/WHT) wire between the right mirror and the 13P connector. If the wire is OK, check the right 
mirror actuator.  

z

If the mirror neither tilts down nor swings left, repair the RED/YEL wire.  

z

If the mirror works properly, check the mirror switch.  

Defogger (Canada): 

8. Connect the No. 12 and No. 11 terminals with a jumper wire, and check for voltage between the No. 2 

terminal of the mirror connectors and body ground. There should be battery voltage and both mirrors 
should warm up with the ignition switch ON (II). 

z

If there is no voltage or neither warms up, check for: 

„

an open in the BLK/YEL or ORN wire.  

„

blown No. 30 (7.5A) fuse in the under-dash fuse/relay box.  

z

If only one fails to warm up, check: 

„

its defogger.  

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Power Mirrors & Automatic Dimming Inside Mirror - TSX

  

 

„

poor ground at G601 (left mirror) or G503 (right mirror).  

z

If both warm up, check the defogger switch.  

POWER MIRROR SWITCH TEST/REPLACEMENT 

1. Remove the driver's door switch trim (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).  

2. Disconnect the 13P connector (A) from the power mirror switch (B). 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Power Mirrors & Automatic Dimming Inside Mirror - TSX

  

 

Fig. 11: Removing The Driver's Door Switch Trim

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Power Mirrors & Automatic Dimming Inside Mirror - TSX