Acura TSX / Honda Accord CL. Manual - part 33

Fig. 11: Removing The Torsion Bar Center Clip From The Body 

4. Install the torsion bars in the reverse order of removal, and note these items: 

z

The shapes of the right torsion bar (A) and left torsion bar (B) are shown. Install the torsion bars 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Exterior Trim - TSX

  

 

properly.  

z

Adjust the torsion bars forward or rearward with the torsion bar assembly tool.  

z

Positions where each torsion bar was installed in the factory are following: 

„

Left torsion bar: Normal position  

„

Right torsion bar: Higher tension  

z

Make sure the trunk lid opens properly and locks securely. 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Exterior Trim - TSX

  

 

Fig. 12: Installing The Torsion Bars 

TRUNK LID WEATHERSTRIP REPLACEMENT 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Exterior Trim - TSX

  

 

1. Remove the trunk lid weatherstrip (A) by pulling it off. 

Fig. 13: Removing The Trunk Lid Weatherstrip 

2. Apply clear sealant (B) into the channel of the trunk lid weatherstrip all the way around. 

Sealant: SUNRISE MEISEI B-33C, or equivalent  

3. Locate the painted alignment mark (C or D) on the trunk lid weatherstrip. Align the painted mark in the 

center of the tailgate opening, and install the trunk lid weatherstrip all the way around in the direction 

 

2004 Acura TSX 

2004 ACCESSORIES & EQUIPMENT Exterior Trim - TSX