|
|
S6M6APPK77100091730FAAT00 − − − − − − − − − − − − DTC P1730: 2005-2006 Models YES NO YES NO YES NO YES NO YES NO YES NO 14-241 Problem in Shift Control System: • Shift Solenoid Valves A or D Stuck OFF NOTE: Record all freeze data and review General 1. Warm up the engine to normal operating temperature (the radiator fan comes on). 2. Make sure that the transmission is filled to the proper level, and check for fluid leaks. 3. Drain the ATF (see step 3 on page 14-272) through a strainer. Inspect the strainer for metal debris or Replace the transmission. Replace the ATF (see step 4 on page 14-272) then go to step 4. 4. Clear the DTC with the HDS. 5. Test-drive the vehicle in the D position through all five gears at speeds over 12 mph (20 km/h) for 6. Retest-drive the vehicle in the D position through all five gears at speeds over 12 mph (20 km/h) for 7. Monitor the OBD status for P1730 in the DTCs/ Freeze Data in A/T Mode Menu for a pass/fail. Go to step 8. Intermittent failure, the system is OK at this time. If the tester indicates NOT COMPLETED, 8. Clear the DTC with the HDS. 9. Choose Shift Solenoid A in Miscellaneous Test Menu, and check that the shift solenoid valve A Go to step 10. Replace shift solenoid valve A (see page 14-260), then go to step 15. 10. Choose Shift Solenoid B in Miscellaneous Test Menu, and check that the shift solenoid valve B Go to step 11. Replace shift solenoid valve B (see page 14-260), then go to step 15. 11. Choose Shift Solenoid D in Miscellaneous Test Menu, and check that the shift solenoid valve D Go to step 12. Replace shift solenoid valve D (see page 14-260), then go to step 15. 12. Test-drive the vehicle in the D position through all five gears at speeds over 12 mph (20 km/h) for 13. Retest-drive the vehicle in the D position through all five gears at speeds over 12 mph (20 km/h) for 14. Monitor the OBD status for P1730 in the DTCs/ Freeze Data in A/T Mode Menu for a pass/fail. Repair hydraulic system related with shift valves A, B, and D, or replace the transmission, Intermittent failure, the system is OK at this time. If the tester indicates NOT COMPLETED, (cont’d) Does the str ainer contain metal debr is or Does the r esult indicate a f ailed? Is a clicking sound hear d? Is a clicking sound hear d? Is a clicking sound hear d? Does the r esult indicate a f ailed? 05/06/27 17:57:13 61S6M040_140_0242 |