Porshe 911 (997). Manual - part 742

Fastening electric line

1. Place front seat in car and tilt backwards.

2. Check tie-wrap -1- , replace tie-wrap -1- if

necessary.

3. Clip wire harness -2- into place.

Connecting electrical plug connection (power seat)

Installation Location:

Overview, removing and installing front seat

Note

Only for vehicles with electrically adjustable seat

Diagnostic system: reading out fault memory and activating systems

Connecting electrical plug connection (power seat)

3125

Locking plug connection for seat memory

1. Push in electrical plug connection -1- -arrow A- until the locking tab audibly engages -arrow B- .

Locking central plug

Installation Location:

Overview, removing and installing front seat

Locking central plug

1. Join the plug connection -1- -arrow A- , press in plug connector locking device -2- on the side -arrow B-

Diagnostic system: reading out fault memory and activating systems

Locking central plug

3126

.

Tightening seat screws at rear

Installation Location:

Overview, removing and installing front seat

DANGER

Loosen the safety-related threaded joint.

Danger of injury if front seat is not screwed down correctly.

• 

→ Always replace fastening screws for the front seat after customer service and reworking.

→ It is not permissible to make alterations to the micro-encapsulated screws (e.g., use lubricant, loosen bolts,

and screw them down again).

Tightening seat screws at rear

1. Tip seat forwards and position seat rails on the seat baseframe.

Diagnostic system: reading out fault memory and activating systems

Tightening seat screws at rear

3127

2. Screw left and right fastening screws -1- into seat bracket -2- and tighten to specified tightening torque →

Micro-encapsulated: 50 (37 ftlb.) Nm

 .

Tightening seat screws at the front

Installation Location:

Overview, removing and installing front seat

DANGER

Loosen the safety-related threaded joint.

Danger of injury if front seat is not screwed down correctly.

• 

→ Always replace fastening screws for the front seat after customer service and reworking.

→ It is not permissible to make alterations to the micro-encapsulated screws (e.g., use lubricant, loosen bolts,

and screw them down again).

1. Connect the battery . →   Work instructions after disconnecting the

battery

Tightening seat screws at the front

Diagnostic system: reading out fault memory and activating systems

Tightening seat screws at the front

3128