Porshe 911 (997). Manual - part 171

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  169  170  171  172   ..

 

 

Porshe 911 (997). Manual - part 171

 

 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Clutch: Checking pedal end position (pedal return/return force)

841

General warning notes

ATTENTION

Increased risk of accidents when removing/installing the clutch boost spring.

Possible risk of damage and injury (e.g. crushing).

• 

→ The boost spring must be secured with a cotter pin when working near the clutch pedal (except for work

on the clutch pedal switch and interlock switch).

Technical values

Location

Explanation

Type

Basic
value

Tolerance 1 Tolerance

2

Master cylinder

Tightening
torque

7.5 ftlb.

Pedal bearing axle

Tightening
torque

6 ftlb.

+1.5 ftlb.

Pedal bearing axle: right lock nut
(M8)

Tightening
torque

7.5 ftlb.

Pedal bearing axle: left lock nut
(M14)

Tightening
torque

34 ftlb.

Bracket for clutch boost spring

Tightening
torque

7.5 ftlb.

Diagnostic system: reading out fault memory and activating systems

Preliminary work

843

Removing

1. Remove the cover and side trim panel for the fusebox in the left driver's footwell.

Clutch pedal switch

2. Carefully pull off the connector from the clutch pedal switch (and if necessary, interlock switch).

-arrows-

3. Remove the relay carrier, vehicle electrical system control unit, and device support on the left above the

clutch pedal.

4. Secure clutch power spring with a cotter pin, for example. Press the clutch pedal lightly, unclip the clutch

power spring and remove.

Clutch master cylinder

5. Loosen the clutch master cylinder -arrows- (do not open the clutch system!) and remove the pin (master

cylinder valve pushrod).

Diagnostic system: reading out fault memory and activating systems

Technical values

844

 

 

 

 

 

 

 

Content   ..  169  170  171  172   ..