Porshe 911 (997). Manual - part 164

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  162  163  164  165   ..

 

 

Porshe 911 (997). Manual - part 164

 

 

Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Subsequent work - three-phase generator

813

27 60 19 Removing and installing starter - as of MY
2005

- Preliminary work
- Removing starter
- Installing starter
- Subsequent work

Preliminary work

Preliminary work - starter

Disconnect battery. → 271000  Work instructions after disconnecting the battery
→ 242519 Removing and installing air cleaner housing - chapter on "removing"
→ 244219 Removing and installing throttle body - chapter on "removing"

Removing starter

Removing starter

Installation Location:

814

Installation position

Unscrewing fastening nuts on starter

1. Remove caps from fastening nuts.

WARNING

If the battery has not been disconnected, battery voltage will be present at the leads during removal and
installation.

Risk of injury from burns and electric shock.

• 

Damage to electrical leads, control units and components due to accidental contact of leads with
ground.

• 

→ Disconnect both battery terminals and cover the + terminal.

2. Unscrew fastening nuts -1, 2- on the starter, remove the leads and lay them to one

side.

Diagnostic system: reading out fault memory and activating systems

Removing starter

815

Unscrewing fastening screws

3. Undo the two fastening screws -3- .

4. Remove the starter rearward from the engine, rotating the starter as necessary.

Installing starter

Installing starter

WARNING

If the battery has not been disconnected, battery voltage will be present at the leads during removal and
installation.

Risk of injury from burns and electric shock.

• 

Damage to electrical leads, control units and components due to accidental contact of leads with
ground.

• 

→ Disconnect both battery terminals and cover the + terminal.

1. Insert and position starter into engine compartment, rotating it slightly aufsetzen.

The angled cable lug of terminal 50 (M6) -1- faces in driving direction after assembly.

Screwing down starter with fastening screws

2.

Diagnostic system: reading out fault memory and activating systems

 Installing starter

816

 

 

 

 

 

 

 

Content   ..  162  163  164  165   ..