Iran Khodro Arisun Pickup. Service Manual - part 1

6

1

YOUR VEHICLE AT A GLANCE

Dashboard

1. Air vents towards front side doors

2. Left speaker location

3. Engine hood release handle

4. Fuse box

5. Side adjustable air vent

6. Horn, front lamp button and indicator 

lever

7. Windshield defrosting and defogging air 

vent

8. Snow wiper and windshield washer 

button

9. Middle adjustable air vent

10. Radio installation place

11. Ashtray

12. Air vent towards side doors

13. Right speaker location

14. Steering wheel angle adjusting lever *

15. Lamp height adjusting button *

16. Dashboard box

17. Inner case of dashboard

*If installed on your vehicle

7

1

YOUR VEHICLE AT A GLANCE

Doors Locking & Unlocking

Doors can be locked/unlocked simultaneously 
by means of key (switch) from outside of the 
vehicle, or by means of locking button of front 
doors designed within the vehicle.

By means of remote control

Mechanism of this device is similar to that 
of key (switch). You shall hold the remote 
control towards its receiver designed on top 
of the interior mirror and press the relevant 
button of remote control, in order to perform 
the expected function.

8

1

YOUR VEHICLE AT A GLANCE

Electric window regulator

1. Electric function – Driver’s window:

The window is adjustable to up and 

down directions by pressing the button 

in relevant direction. Release the button 

when the window is adjusted in the place 

you wish.

2. Electric function – Passenger’s 

window up/down adjusting button

This button is designed on left door. Also, 

there is an adjusting key for the window of 

this door on the right door. 

Seats

 

Front seats manual adjustment

1. Seats fore-and aft adjustment: Push 

the locker handle up and move the seat 

as much as the seat is located in your 

favorite position, then release the handle 

to make it locked in this position.

2. Backrest inclination adjustment: Press 

the lever and move the backrest until it 

reaches to your favorite position.

3. Headrest adjustment: Pull the headrest 

up to adjust its height.

9

1

YOUR VEHICLE AT A GLANCE

Left and Right indicator lamps

Positions 1 & 2: Before turning to left, pull 

the lever downwards, and before turning 

to right, pull the lever upwards. (The green 

warning lamp will blinks according to 

turning direction on the instrument panel 

display.)

In case of knocking once on the left or 

right indicator, the indicator lamp will be 

activated and will go out after 4 flashings. 

(Number  of  flashers  are  adjustable  with 

diagnostic instrument.)*

Horn

Position 3: In order to make horn, press 

the button designed at the end of indicator 

lever.

Low and High Beams

In order to shift through low and high 

beams, pull the lever completely towards 

the steering wheel (in this mode, the blue 

indicator lamp of high beam will be turned 

on). In order to make a signal with main 

lamps (lighting), pull the lever near the 

steering wheel and release it.

Lamps button

Position 1: All lamps OFF.

Position 2: Position lamps, tail lamps, and 

instrument panel display lamps.

Position 3: Headlamps ON.

Warning Beep

It warns the driver when he leaves the 

vehicle and the headlamps are ON, it will 

beep when the driver’s door is opened 

and the switch is OFF.

Warning

Before starting to drive at night: Ensure the appropriate functioning of electric equipment and adjust 
the vehicle lamps. (In case of overloading) generally, ensure that the lamps are not covered. (Dirt, 
mud, snow or any other object are not covering the lamps.)

10

1

YOUR VEHICLE AT A GLANCE

Front Fog Lamps

In order to turn on the front fog lamps, turn 

the middle part of indicator lever one step 

upwards. When the fog lamps are turned 

on, the relevant indicator lamp will emerge 

on the instrument panel display.

These lamps are able to be turned on only 

when the main headlamps or positions 

lamps are turned on. 

Rear Fog Lamps

In order to turn on the rear fog lamps, turn 

the middle part of indicator lever two step 

upwards. When the fog lamps are turned 

on, the relevant indicator lamp will emerge 

on the instrument panel display.

These lamps are able to be turned on 

providing that:

-The main headlamps or position lamps 

are turned on.

-The side lamps or front fog lamps (if 

existing) are turned on.

Pay attention to make use of fog lamps 

only when the scope of vision is limited, 

because in ordinary vision conditions, it 

will annoy other drivers.

*If installed on your vehicle

11

1

YOUR VEHICLE AT A GLANCE

Snow Wiper

The snow wipers and windshield washer are 

controlled by the lever designed on right side of 

steering wheel providing that the switch is OPEN.

0- OFF

1- Intermittent snow wiper* (The interval between 

two movements of snow wiper is dependent on the 

vehicle’s speed.)

2- Low speed

3- High speed

Single-step wiping (just one cycle)

For just one movement of snow wiper, pull the 

lever downwards just once and then release it.

By holding the lever downwards, the snow wiper 

will move continuously.

Windshield Washing

In order to wash the windshield, pull the lever 

towards yourself. By pulling the lever once, 

the snow wipers will move three times, as 

long as you hold the lever, the windshield 

washer will keep on functioning.

By pulling the lever, the water spraying 

will be started, and after water spraying, 

the snow wipers will start to move for 0.7 

second. As long as you hold the lever, the 

function of water spraying and washing will 

keep on without any stop, but immediately 

after releasing the lever, the snow wipers 

will stop after three moves. At most after 

3 seconds from stop, the complementary 

fourth movement of snow wiper for cleaning 

the windshield completely will function.*

*If installed on your vehicle

Warning

In time of freezing, ensure the snow wiper blades are not frozen. (Risk of overheating of snow wiper motor.)

Check the status of blades. When the blades performance is weak, you shall replace them. (approximately 

once a year.)

Clean the front windshield regularly, In case you turn off the vehicle engine before turning off the motor of 

snow wiper (Mode 0), the wiper blades will stop in their current position.

After powering on the vehicle engine, it is enough to set the snow wiper lever in 0 mode, to return the wiper 

blades in STOP position.

When you want to open the engine hood, please ensure that the snow wiper blade is in 0 mode (STOP). 

(Risk of injury).

12

1

YOUR VEHICLE AT A GLANCE

In order to shift to low beam mode, pull 

the indicator lamp once again towards the 

steering wheel.

Lamps – Horn

Warning Signals

1- Horn: Press the end of the indicator lever 

inwards.

2- High Beam Signaling: Pull the indicator 

lever towards the steering wheel.

3- Indicator Lamps:

- 

 

Right side: Pull the indicator lever 

upwards.

- Left side: Pull the indicator lever downwards.

- Overtaking or Pathway shift situation:

Shortly pull the indicator lamp on desired 

direction.

- Complete pathway shift: For complete turning, 

pull the indicator lever to the end, towards the 

desired direction.

-The indicator lever will return to its initial 

position automatically as a result of turning of 

steering wheel.

4- Flasher lamp

 Flasher lamp button is designed on the 

Radio playback device.

Warning Beep

It warns the driver when he leaves the vehicle 
and the headlamps are ON, it will beep when a 
door is opened and the switch is OFF.

13

1

YOUR VEHICLE AT A GLANCE

Air ventilation – Heating

Air Ventilation System

1- Defrosting and defogging the glasses.

2- Side air vents.

3- Middle air vents.

4- Front passenger foot air vents.

14

1

YOUR VEHICLE AT A GLANCE

Audio system, Heating and Ventilation

1- Air vent

2- Audio system

3- Fuel consumption status shift to CNG 

button

4- Hazard warning lamp button (Flasher)

5- Heating and ventilation adjustment 

panel

Ventilation, Heating and Air Distribution

1. Air vent adjustment knob

2. Interior Air Circulation Button

3. Temperature adjustment knob

4. A/C switch

5. Air fan speed adjustment knob

15

1

YOUR VEHICLE AT A GLANCE

Opening engine hood

1- From inside the cabin (driver’s side), 

pull the lock releasing handle of engine 

hood, the engine hood will move slightly 

upwards in this mode.

2- Pull the safety handle of engine hood, 

then move up the engine hood.

Closing engine hood

Put the engine hood strut in hinge place 

again, then move the engine hood down 

and release the engine hood from 30 cm 

height in order to close it.

17

BEFORE DRIVING

2

*If installed on your vehicle

CONFIDENTIAL CODE CARD ............................................ 19

DOORS LOCKING & UNLOCKING .................................... 20

IMMOBILIZER SYSTEM ...................................................... 22

ELECTRIC WINDOW REGULATOR ................................... 23

SEATS .................................................................................. 23

MIRRORS ............................................................................. 24

SAFETY CONSIDERATIONS  ............................................. 24

STEERING WHEEL  .................................................................. 26

HEATING & VENTILATION  ..................................................... 27

INTERIOR EQUIPMENT  .......................................................... 31

OPERATION OF RADIO/CD  .................................................... 32

CNG FUEL SYSTEM*  .............................................................. 35

SAFETY BELT ........................................................................... 43

AIRBAG  ..................................................................................... 45

18

2

DOORS LOCKING & UNLOCKING

Doors Locking & Unlocking

Engine Hood

1- From inside the vehicle, pull the 

engine hood releasing handle toward 

yourself, to release its hinge.

2- From outside the vehicle, put the engine 

hood releasing handle toward yourself to 

release the safety hinge of the lock.

Make use of strut to hold the engine hood 

opened.

For closing the engine hood, move down 

the strut, and release the engine hood 

from approximately 30 cm height, now 

ensure that the engine hood is completely 

locked.

19

2

DOORS LOCKING & UNLOCKING

By means of Remote Control

The function of this device is similar to 

that of the key. In order to function with 

this device, hold it in line with its receiver 

designed on top of the interior mirror and 

press its button.

This device works with two 3V batteries. 

You shall replace the batteries if the 

device LED does not function.

Fuel tank cap

After inserting the switch in the fuel tank 

cap and turning it, take action to open the 

fuel tank cap and perform the refueling 

action. It is necessary to mention that, 

you will not be able to take out the switch 

from fuel tank cap till you put the lip in its 

appropriate place and lock it.

20

2

Immobilizer System

These keys will check the engine after 

some moments from engine powering 

OFF, and by this means will prevent 

engine powering ON with any key except 

the main key (Main Switch).

Each key has an electronic segment 

which has a special code. When the key 

is inserted in locks core, the key code will 

be diagnosed and starting will be possible. 

If the key does not have code, or if it has 

a code which does not conform with the 

code saved in system memory, the engine 

start will be function.

Confidential Code Card

This card includes an identification code 

which the authorized dealer needs it when 

working on system.

This code is covered by a label, which 

can be removed in order to access to the 

code.

The ID card of your vehicles shall be kept 

in a safe place, and you shall never put it 

in your vehicle.

Existence of a flashing indicator lamp on 

the front panel (as the image) when the 

vehicle is powered OFF, will be indicate 

installation of this system on your vehicle.

Flashing Indicator

DOORS LOCKING & UNLOCKING

21

2

Warning

In order to decrease the possible physical 

damage and ensure the safety of driver and 

front passenger, it is necessary to comply with 

the above images in respect with adjustment 

of headrest height and position of head to the 

headrest. 

Electric window regulator

1. Electric function – Driver’s key:

The window is adjustable to up and 

down directions by pressing the button 

in relevant direction. Release the button 

when the window is adjusted in the place 

you wish.

2. Electric function – Passenger’s 

key up/down adjusting button

This button is designed on left door. Also, 

there is an adjusting key for the window of 

this door on the right side.

Seats

Manual Adjustment of Seats:

1. Moving the seat forward or backward: 

Push the locker handle up and move the 

seat as much as the seat is located in your 

favorite positions, then release the handle 

to make it locked in this position.

2. Backrest inclination adjustment: Hold 

the lever up and move the backrest until it 

reaches to your favorite position.

3. Headrest adjustment: Pull up the 

headrests to adjust their height.

SEATS

22

2

Mirrors

Interior Rearview Mirror

4- Interior rearview mirror is adjustable for 

two modes of driving at day and driving at 

night.

ATTENTION

Avoid putting extra and thick foot pad 

beneath the driver’s feet, because non-

standard foot pad will impede complete 

course of clutch pedal and ease of gear 

shift.

Fastening Seat Belt

2- Pulley Belts:

 Smoothly pull out the 

belt in a way that its pulley is not locked, 

then, insert the latch plate into the buckle.

At severe brake or sudden acceleration, 

and in slopes and severe turns, the safety 

belt will be locked.

3- Release of safety belt

Press the red color button.

Safety Belts

Safety Considerations

- Regularly check the status of hooks of safety 

belts.

- After each accident, check the reliance and 

connection points of safety belts.

- If it is required to replace the safety belt, you 

shall make use of standard spare safety belt 

produced by the same manufacturer.

- Never try to change the place of safety belts’ 

installation.

- Safety belts are able to be adjusted for children 

below 6 years-old, seating on high chair for 

children.

Safety Belt Adjustment

1- In order to adjust the height of front seat belts, 

pull out its adjusting handle slightly, move the 

upper hook of safety belt from its related sliding 

rails, then release the locking handle in desired 
place to lock it.

SAFETY CONSIDERATIONS

CAUTION

Never allow infants and children to 

seat on the foot of passengers. There 

are risks of severe damages specially 

when the children are seating on 

your foot. Never make use of one 

safety belt to fasten two persons 

simultaneously. 

CAUTION

-Avoid adjusting the seat during vehicle movement.

-Safety belts will have their complete function when the inclination of backrest to vertical line is 

approximately 25 degrees.

-Taking into consideration that the headrest is a safety tool, always ensure its existence and its 

appropriate position in its place.