|
|
Section 05 ENGINE MANAGEMENT (POWER TEK) A33C4XA 1 1 1. Install hose pinchers – disconnect inlet and outlet coolant hoses from carburetors NOTE: Keep throttle cable installed to avoid fur- – properly rotate and slightly pull out carburetors to gain access to TPS NOTE: Mark hose locations of E-RAVE solenoid – remove solenoid screws and solenoid. For installation, reverse the removal procedure. DPM SOLENOID Electrical Test Connect vehicle communication kit (VCK) and use Energize Leaning valve (DPM solenoid) from Ac- A33C5JA This will validate the solenoid mechanical and elec- Listen to or touch relay to feel it clicks. If the solenoid does not work, disconnect the con- NOTE: To gain access to connector pins, unlock Measure voltage between pin 2 of DPM sole- If 12 V is read, disconnect connector from the If it does not read 12 V, check the corresponding Replacement Refer to FUEL SYSTEM. IGNITION COIL A33C55A 1 RH SIDE OF VEHICLE The ECM energizes the primary side of ignition Connect vehicle communication kit (VCK) and use Energize ignition coil from Activation tab. 226 mmr2005-107 |