|
|
Content .. 2622 2623 2624 2625 ..
2. CLEAR DTC a. Connect the Techstream to the DLC3. b. Turn the ignition switch ON. c. Turn the Techstream on. d. Enter the following menus: Body Electrical/Occupant Detection/Trouble Codes. e. Erase the DTCs. DATA LIST/ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and a. Connect the Techstream to the DLC3. b. Turn the ignition switch ON. c. Turn the Techstream on. d. Enter the following menus: Body Electrical/Occupant Detection/Data List. e. According to the display on the Techstream, read the "Data List". Occupant Detection: DATA LIST TABLE NOTE: In the table below, the values listed under "Normal Condition" are Tester Display Test Part Control Range Diagnostic Note IG Switch Ignition switch condition/ ON/OFF - Passenger Buckle switch (Passenger side)/ Unset/Set - Passenger classification/ AM50:
2009 Toyota Tundra 2009 RESTRAINTS Supplemental Restraint System - Tundra
|