|
|
Content .. 997 998 999 1000 ..
PWC-108 < DTC/CIRCUIT DIAGNOSIS > [DRIVER SIDE WINDOW ANTI-PINCH] ENCODER CIRCUIT YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK ENCODER POWER SUPPLY 1. Connect power window main switch connector. 2. Turn ignition switch ON. 3. Check voltage between front power window motor (driver side) harness connector and ground. Is the inspection result normal? YES >> GO TO 5. NO >> GO TO 4. 4. CHECK ENCODER POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect power window main switch connector. 3. Check continuity between power window main switch harness connector and front power window motor 4. Check continuity between power window main switch harness connector and ground. Is the inspection result normal? YES >> Replace power window main switch. Refer to PWC-123, "Removal and Installation" NO >> Repair or replace harness. 5. CHECK ENCODER GROUND CIRCUIT 1 1. Turn ignition switch OFF. 2. Disconnect power window main switch connector. 3. Check continuity between power window main switch harness connector and front power window motor 4. Check continuity between power window main switch harness connector and ground. Is the inspection result normal? YES >> GO TO 6. NO >> Repair or replace harness. 6. CHECK ENCODER GROUND CIRCUIT 2 1. Connect power window main switch connector. (+) (-) Voltage (V) Front power window motor (driver side) Connector Terminal D7 4 Ground 9 – 16 Power window main switch Front power window motor (driver side) Continuity Connector Terminal Connector Terminal D5 15 D7 4 Existed Power window main switch Ground Continuity Connector Terminal D5 15 Not existed Power window main switch Front power window motor (driver side) Continuity Connector Terminal Connector Terminal D5 2 D7 6 Existed Power window main switch Ground Continuity Connector Terminal D5 2 Not existed |