|
|
LAN-174 < DTC/CIRCUIT DIAGNOSIS > [CAN SYSTEM (TYPE 6)] MAIN LINE BETWEEN ABS AND DLC CIRCUIT MAIN LINE BETWEEN ABS AND DLC CIRCUIT Diagnosis Procedure INFOID:0000000009979383 1. CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector side - Harness connector E105 - Harness connector M11 Is the inspection result normal? YES >> GO TO 2. NO >> Repair the terminal and connector. 2. CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Disconnect the following harness connectors. - ABS actuator and electric unit (control unit) - Harness connectors E105 and M11 2. Check the continuity between the ABS actuator and electric unit (control unit) harness connector and the Is the inspection result normal? YES >> GO TO 3. NO >> Repair the main line between the ABS actuator and electric unit (control unit) and the harness connector E105. 3. CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Check the continuity between the harness connector and the data link connector. Is the inspection result normal? YES (Present error)>>Check CAN system type decision again. unit) and the data link connector. NO >> Repair the main line between the harness connector M11 and the data link connector. ABS actuator and electric unit (control unit) harness connector Harness connector Continuity Connector No. Terminal No. Connector No. Terminal No. E36 23 E105 14 Existed 21 15 Existed Harness connector Data link connector Continuity Connector No. Terminal No. Connector No. Terminal No. M11 14 M4 6 Existed 15 14 Existed |