|
|
Content .. 1020 1021 1022 1023 ..
SUNROOF SWITCH RF-31 < DTC/CIRCUIT DIAGNOSIS > C D E F G H I J L M A B RF N O P Is the inspection result normal? YES >> GO TO 4. NO >> Repair or replace harness or connector. 4. CHECK FRONT SUNROOF SWITCH Check front sunroof switch. RF-32, "REAR SUNROOF SWITCH (FRONT) : Component Inspection" Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident" . NO >> Replace sunroof switch (front). Refer to RF-71, "FRONT : Removal and Installation" . FRONT SUNROOF SWITCH : Component Inspection INFOID:0000000009650366 SUNROOF SWITCH 1. CHECK FRONT SUNROOF SWITCH 1. Turn ignition switch OFF. 2. Disconnect front sunroof switch harness connector. 3. Check continuity front sunroof switch terminals. Is the inspection result normal? YES >> INSPECTION END NO >> Replace sunroof switch (front). Refer to RF-71, "FRONT : Removal and Installation" . REAR SUNROOF SWITCH (FRONT) REAR SUNROOF SWITCH (FRONT) : Component Function Check INFOID:0000000009650367 1. CHECK FUNCTION Check tilt up/down and slide open/close operations with rear sunroof switch (front). Is the inspection result normal? YES >> INSPECTION END NO >> Refer to RF-31, "REAR SUNROOF SWITCH (FRONT) : Diagnosis Procedure" REAR SUNROOF SWITCH (FRONT) : Diagnosis Procedure INFOID:0000000009650368 1. CHECK REAR SUNROOF SWITCH (FRONT) INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect rear sunroof switch (front) and rear sunroof switch (rear) harness connector. 3. Turn ignition switch ON. 4. Check voltage between rear sunroof switch (front) harness connector and ground. Front sunroof switch Ground Continuity Connector Terminal R6 2 Existed Terminal Condition Continuity 1 2 Front sunroof switch Tilt down or slide open Existed Other than the above Not existed 3 Tilt up or slide close Existed Other than the above Not existed |