Content .. 594 595 596 597 ..

Nissan March K13. Manual - part 596

SECURITY INDICATOR LAMP

SEC-123

< DTC/CIRCUIT DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

SEC

Is the inspection result normal?

YES

>> Replace combination meter. Refer to

MWI-51, "Removal and Installation"

>> Repair or replace harness.

Combination meter

Ground

Continuity

Connector

Terminal

M34

Not existed

SEC-124

< SYMPTOM DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

ENGINE DOES NOT START WHEN INTELLIGENT KEY IS INSIDE OF VEHICLE

SYMPTOM DIAGNOSIS

ENGINE DOES NOT START WHEN INTELLIGENT KEY IS INSIDE OF VE-
HICLE

Description

INFOID:0000000006038627

Engine does not start when push-button ignition switch is pressed while carrying Intelligent Key.
NOTE:
• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and

check each symptom.

• The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelli-

gent Key system are closely related to each other regarding control. The vehicle security function can oper-
ate only when the door lock and power distribution system are operating normally.

Conditions of Vehicle (Operating Conditions)

• “ENGINE START BY I-KEY” setting in “WORK SUPPORT” mode is ON.
• Intelligent Key is not inserted in key slot.
• One or more of Intelligent Keys with registered Intelligent Key ID is in the vehicle.

Diagnosis Procedure

INFOID:0000000006038628

PERFORM WORK SUPPORT

Perform “INSIDE ANT DIAGNOSIS” on Work Support in “INTELLIGENT KEY”.
Refer to

SEC-19, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY)"

>> GO TO 2.

PERFORM SELF-DIAGNOSIS RESULT

Select “Self Diagnostic Result” mode of “BCM”, and check whether or not DTC of inside key antenna is
detected.

Is DTC detected?

YES

>> Refer to

DLK-46, "DTC Logic"

(instrument center) or

DLK-50, "DTC Logic"

(luggage room).

>> GO TO 3.

CHECK PUSH-BUTTON IGNITION SWITCH

Check push-button ignition switch.
Refer to

PCS-87, "Component Function Check"

Is the operation normal?

YES

>> GO TO 4.

>> Repair or replace malfunctioning parts.

CONFIRM THE OPERATION

Confirm the operation again.

Is the inspection normal?

YES

>> Check intermittent incident. Refer to

GI-33, "Intermittent Incident"

>> GO TO 1.

STEERING DOES NOT LOCK

SEC-125

< SYMPTOM DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

SEC

STEERING DOES NOT LOCK

Description

INFOID:0000000006038629

Steering does not lock when door is open while ignition switch is OFF.
NOTE:
Before performing the diagnosis, check “Work Flow”. Refer to

SEC-33, "Work Flow"

Diagnosis Procedure

INFOID:0000000006038630

CHECK DOOR SWITCH

Check door switch.
Refer to

DLK-58, "Component Function Check"

Is the inspection normal?

YES

>> GO TO 2.

>> Repair or replace malfunctioning parts.

CONFIRM THE OPERATION

Confirm the operation again.

Is the inspection normal?

YES

>> Check intermittent incident. Refer to

GI-33, "Intermittent Incident"

>> GO TO 1.

SEC-126

< SYMPTOM DIAGNOSIS >

[WITH INTELLIGENT KEY SYSTEM]

SECURITY INDICATOR LAMP DOES NOT TURN ON OR BLINK

SECURITY INDICATOR LAMP DOES NOT TURN ON OR BLINK

Description

INFOID:0000000006038631

Security indicator lamp does not blink when ignition switch is in a position other than ON
NOTE:
• Before performing the diagnosis, check “Work Flow”. Refer to

SEC-33, "Work Flow"

• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and

check each symptom.

Conditions of Vehicle (Operating Conditions)

Ignition switch is not in the ON position.

Diagnosis Procedure

INFOID:0000000006038632

CHECK SECURITY INDICATOR LAMP

Check security indicator lamp.
Refer to

SEC-122, "Component Function Check"

Is the inspection result normal?

YES