|
|
ADP-112 < DTC/CIRCUIT DIAGNOSIS > DOOR MIRROR REMOTE CONTROL SWITCH Is the inspection result normal? YES >> Inspection End. NO >> Replace door mirror remote control switch. Refer to MIR-22, "Removal and Installation" MIRROR SWITCH INFOID:0000000009176614 It operates angle of the door mirror face. It transmits mirror face adjust operation to automatic drive positioner control unit. MIRROR SWITCH : Component Function Check INFOID:0000000009176615 1. CHECK FUNCTION 1. Select “MIR CON SW-UP/DN”,“MIR CON SW-RH/LH “ in “DATA MONITOR” mode with CONSULT. 2. Check mirror switch signal under the following conditions. Is the inspection result normal? YES >> Inspection End. NO >> Perform diagnosis procedure. Refer to ADP-112, "MIRROR SWITCH : Diagnosis Procedure" MIRROR SWITCH : Diagnosis Procedure INFOID:0000000009176616 Regarding Wiring Diagram information, refer to ADP-55, "WITH AROUND VIEW MONITOR : Wiring Diagram" or ADP-40, "WITHOUT AROUND VIEW MONITOR : Wiring Diagram" . 1. CHECK MIRROR SWITCH FUNCTION 1. Turn ignition switch ON. 2. Check voltage between automatic drive positioner control unit connector and ground. Is the inspection result normal? YES >> GO TO 5. NO >> GO TO 2. 2. CHECK HARNESS CONTINUITY Monitor item Condition Status MIR CON SW-UP/DN Mirror switch (up/down) Operate ON Release OFF MIR CON SW-RH/LH Mirror switch (right/left) Operate ON Release OFF (+) (–) Mirror switch Condition Voltage (V) (Approx.) Automatic drive positioner con- trol unit Connector Terminal M33 3 Ground UP 0 Other than above 5 4 LEFT 0 Other than above 5 15 DOWN 0 Other than above 5 16 RIGHT 0 Other than above 5 |