|
|
Content .. 1135 1136 1137 1138 ..
TM-72 < COMPONENT DIAGNOSIS > [CVT: RE0F09B] P0778 PRESSURE CONTROL SOLENOID B ELECTRICAL (SEC PRESSURE SOLENOID VALVE) P0778 PRESSURE CONTROL SOLENOID B ELECTRICAL (SEC PRES- Description INFOID:0000000003848998 The pressure control solenoid valve B (secondary pressure solenoid valve) regulates the oil pump discharge DTC Logic INFOID:0000000003848999 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. 1. CHECK DTC DETECTION With CONSULT-III 1. Start engine. 2. Drive vehicle and maintain the following conditions for at least 5 consecutive seconds. 3. Perform “Self-Diagnostic Results” mode for “TRANSMISSION”. With GST Follow the procedure “With CONSULT-III”. Is “P0778 PRS CNT SOL/B CIRC” detected? YES >> Go to NO >> Check intermittent incident. Refer to GI-35, "Intermittent Incident" . Diagnosis Procedure INFOID:0000000003849000 1. CHECK PRESSURE CONTROL SOLENOID VALVE B (SECONDARY PRESSURE SOLENOID VALVE) CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect TCM connector. 3. Check resistance between TCM vehicle side harness connector terminal and ground. Is the inspection result normal? YES >> GO TO 5. NO >> GO TO 2. 2. CHECK HARNESS BETWEEN TCM AND PRESSURE CONTROL SOLENOID VALVE B (SECONDARY PRESSURE SOLENOID VALVE) (PART 1) 1. Disconnect CVT unit connector. 2. Check continuity between TCM vehicle side harness connector terminal and CVT unit vehicle side har- DTC Item (CONSULT-III screen term) Malfunction is detected when... Possible cause P0778 PRS CNT SOL/B CIRC • Normal voltage is not applied to solenoid due to cut line, short, etc. • TCM detects as irregular by comparing target value with monitor value. • Harness or connectors (Solenoid circuit is open or shorted.) • Pressure control solenoid valve B (sec- ondary pressure solenoid valve) TCM vehicle side harness connector Ground Resistance (Approx.) Connector Terminal F23 39 3.0 – 9.0 Ω |