|
|
B2112 SLIDING MOTOR ADP-41 < COMPONENT DIAGNOSIS > C D E F G H I K L M A B ADP N O P B2112 SLIDING MOTOR Description INFOID:0000000003759103 • The sliding motor is installed to the seat cushion frame. DTC Logic INFOID:0000000003759104 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. STEP 1 1. Turn ignition switch ON. 2. Check “Self diagnostic result” with CONSULT-III. Is the DTC detected? YES >> Refer to . NO >> INSPECTION END Diagnosis Procedure INFOID:0000000003759105 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check “Self diagnostic result” with CONSULT-III. 3. Erase the DTC. 4. Perform DTC confirmation procedure. Refer to . Is the DTC displayed again? YES >> GO TO 2. NO >> GO TO 4. 2. CHECK SLIDING MOTOR CIRCUIT (POWER SHORT) 1. Turn ignition switch OFF. 2. Disconnect sliding motor connector and driver seat control unit connector. 3. Check voltage between sliding motor harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair or replace harness. 3. CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL 1. Connect driver seat control unit connector. 2. Check voltage between driver seat control unit harness connector and ground. DTC No. Trouble diagnosis name DTC detecting condition Possible cause B2112 SEAT SLIDE The driver seat control unit detects the output of sliding • Driver seat control unit (+) (–) Voltage (V) (Approx.) Sliding motor Connector Terminal B461 3 Ground 0 4 |