|
|
содержание .. 1469 1470 1471 1472 ..
WT-4 < PRECAUTION > PRECAUTIONS Always observe the following items for preventing accidental activation. ignition ON or engine running, never use air or electric power tools or strike near the sensor(s) with • When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the battery, and wait at least 3 minutes before performing any service. Precautions for Removing of Battery Terminal INFOID:0000000010069720 • When removing the 12V battery terminal, turn OFF the ignition switch and wait at least 30 seconds. • For vehicles with the 2-batteries, be sure to connect the main bat- tery and the sub battery before turning ON the ignition switch. • After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC. NOTE: Service Notice and Precautions for TPMS INFOID:0000000009722236 • Low tire pressure warning lamp blinks for 1min, then turns ON when occurring any malfunction except low tire pressure. Delete the memory with CONSULT, or register the ID to turn low tire pressure warning lamp WT-10, "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONI- • ID registration is required when replacing or rotating wheels, replacing tire pressure sensor or BCM. Refer to • Replace grommet seal, valve core and cap of tire pressure sensor in TPMS every tire replacement by reach- ing wear limit of tire. Refer to Service Notice and Precautions for Road Wheel INFOID:0000000009722237 • Genuine NISSAN aluminum wheel is designed for each type of vehicle. Use it on the specified vehicle only. num wheel weights. • Use caution when handling the aluminum wheels, because they can be easily scratched. When removing dirt, do not use any abrasives, a wire brush, or other items that may scratch the coating. Use a neutral deter- • After driving on roads scattered with anti-icing salts, wash off the wheels completely. from being trapped between the contact surfaces of wheel. • Never apply oil to nut and bolt threads. SEF289H |