|
|
содержание .. 482 483 484 485 ..
EC-586 < COMPONENT DIAGNOSIS > [HR16DE (WITHOUT EURO-OBD)] P2138 APP SENSOR 12. DETECT MALFUNCTINING PART • Harness or connectors E7, M69, M25, M201 (RHD models). >> Repair open circuit or short to ground or shot to power in harness or connectors. 13. CHECK APP SENSOR EC-586, "Component Inspection" Is the inspection result normal? YES >> GO TO 15. NO >> GO TO 14. 14. REPLACE ACCELERATOR PEDAL ASSEMBLY 1. Replace accelerator pedal assembly. 2. Go to EC-586, "Special Repair Requirement" . >> INSPECTION END 15. CHECK INTERMITTENT INCIDENT GI-55, "Intermittent Incident" >> INSPECTION END Component Inspection INFOID:0000000001693414 1. CHECK ACCELERATOR PEDAL POSITION SENSOR 1. Reconnect all harness connectors disconnected. 2. Turn ignition switch ON. 3. Check the voltage between ECM harness connector terminals as follows. Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2. REPLACE ACCELERATOR PEDAL ASSEMBLY 1. Replace accelerator pedal assembly. 2. Go to EC-586, "Special Repair Requirement" . >> INSPECTION END Special Repair Requirement INFOID:0000000001693415 1. PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING Refer to EC-389, "ACCELERATOR PEDAL RELEASED POSITION LEARNING : Special Repair Require- >> GO TO 2. (+) (–) Condition Voltage Connector Terminal Connector Terminal E16 110 (APP sensor 1 signal) E16 111 Accelerator pedal Fully released 0.6 - 0.9V Fully depressed 3.9 - 4.7V 103 (APP sensor 2 signal) 104 Fully released 0.3 - 0.6V Fully depressed 1.95 - 2.4V |