|
|
Starter Drive Starter motor loose on Tighten starter Will Not mountings attach bolts Disengage Worn drive end bushing See STARTER article Damaged engine flywheel Replace flywheel and teeth starter pinion gear for damage Drive yolk return spring Replace return spring broken or missing Faulty ignition switch Replace ignition switch Insufficient clearance Replace starter between winding leads to solenoid solenoid terminal and main contact in solenoid Starter clutch not Replace starter clutch disengaging Ignition starter switch Replace ignition switch contacts sticking Starter Relay Faulty solenoid switch, Check all wiring Operates but switch connections or between relay and Solenoid Does Not solenoid or replace relay or solenoid as necessary Broken lead or loose Repair wire or wire soldered connections connections as necessary Solenoid Plunger Weak battery Charge or replace Vibrates When battery as necessary Switch is Engaged Solenoid contacts Clean contacts or corroded replace solenoid Faulty wiring Check all wiring leading to solenoid Broken connections inside Repair connections or switch cover replace solenoid Open hold-in wire Replace solenoid Low Current Draw Worn brushes or weak Replace brushes or brush springs as necessary High Pitched Whine Distance too great Align starter or check During Cranking between starter that correct starter Before Engine pinion and flywheel and flywheel are being Fires but Engine used Fires and Cranks Normally High Pitched Distance too small between Whine After Engine starter pinion and flywheel |