Mitsubishi Galant. Manual - part 7

 

  Index      Mitsubishi     Mitsubishi Galant - service repair manual 2001 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  5  6  7  8   ..

 

 

Mitsubishi Galant. Manual - part 7

 

 

TOWING AND HOISTING

TSB Revision

GENERAL <BODY AND CHASSIS>

00-25

TO W IN G  A N D  H O ISTIN G

M1001000800119

WRECKER TOWING RECOMMENDATION

FRONT TOWING PICKUP

CAUTION

This vehicle cannot be towed by a wrecker using sling-
type equipment to prevent the bumper from deformation. If 
this vehicle is towed, use wheel lift or flat bed equipment.
The vehicle may be towed on its rear wheels for extended 
distances provided the parking brake is released. It is 
recommended that vehicles be towed using the front pickup 
whenever possible.

REAR TOWING PICKUP 

CAUTION

This vehicle cannot be towed by a wrecker using sling-
type equipment to prevent the lower arm from 
deformation. If this vehicle is towed, use a wheel lift or 
flat bed equipment.

Do not use the steering column lock to secure the front 
wheel for towing.

Make sure the transaxle is in Neutral if vehicle will have 
drive wheels on the ground.

If these limits cannot be met, the front wheels must be 
placed on a tow dolly.

Automatic transaxle vehicle may be towed on the front wheels 
at speeds not to exceed 50 km/h (30 mph) for distances not to 
exceed 30 km (18 miles).

TOWING WHEN KEYS ARE NOT AVAILABLE 
When a locked vehicle must be towed and keys are not 
available, the vehicle may be lifted and towed from the front, 
provided the parking brake is released. If not released, the rear 
wheels should be placed on a tow dolly.

AC000070AB

SLIDING TYPE

WHEEL LIFE TYPE

FLAT BED TYPE

AC000071AB

SLIDING TYPE

WHEEL LIFE TYPE

FLAT BED TYPE

TOWING AND HOISTING

TSB Revision

GENERAL <BODY AND CHASSIS>

00-26

SAFETY PRECAUTIONS
The following precautions should be taken when towing the 
vehicle:

1. DO NOT LIFT OR TOW THE VEHICLE BY ATTACHING 

TO OR WRAPPING AROUND THE BUMPER.

2. Any loose or protruding parts or damaged vehicle such as 

hoods, doors, fenders, trim, etc. should be secured or 
removed prior to moving the vehicle.

3. Operator should refrain from going under a vehicle it is lifted 

by the towing equipment, unless the vehicle is adequately 
supported by safety stands.

4. Never allow passengers to ride in a towed vehicle.
5. State and local rules and regulations must be followed 

when towing a vehicle.

TOWING AND HOISTING

TSB Revision

GENERAL <BODY AND CHASSIS>

00-27

LIFTING, JACKING SUPPORT LOCATION

FLOOR JACK

CAUTION

Never support any point other than the specified one, or it will be deformed.

For lifting, put rubber or similar material between the side sill and rigid rack, or the side sill area 
will be damaged.

POST TYPE 
Special care should be taken when raising the 
vehicle on a frame contact type hoist. The hoist must 
be equipped with the proper adapters in order to 
support the vehicle at the proper locations.

AC004830 AB

RIGID RACK

NOTCH

NOTCH

RUBBER

RUBBER

GENERAL DATA AND SPECIFICATIONS

TSB Revision

GENERAL <BODY AND CHASSIS>

00-28

CAUTION

When service procedures require removing rear suspension, fuel tank and spare tire, place additional 
weight on rear end of vehicle or anchor  vehicle to hoist to prevent tipping of center of gravity 
changes.

G EN ERA L DATA  A N D  SPEC IFIC ATIO NS

M1001000900116

AC004831

NOTCH

NOTCH

AB

AC004832

1

2

3

4

5

6

7

8

9

AB

 

 

 

 

 

 

 

Content   ..  5  6  7  8   ..