|
|
ENGINE 10 OVERHAUL Camshaft - check end-float NOTE: Prior to removing the camshaft, 1. Position a suitable DTI to front of camshaft. Move camshaft rearwards and zero DTI. Move CAUTION: Camshaft end-float is exceeds the above dimension, remove the Camshaft - remove 1. Using sequence shown, loosen the 10 camshaft carrier retaining bolts 2 to 3 turns. CAUTION: Do not fully remove bolts at this 2. Gently tap the camshaft carrier upwards to break the sealant bond. CAUTION: Camshaft carrier is dowel 3. Using the same sequence, continue to progressively loosen the carrier retaining bolts CAUTION: If bolts are removed completely suddenly released and damage caused as a 4. Remove retaining bolts, remove camshaft carrier. |