|
|
6E1–107 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION Up-Shift Lamp System Check (Cont'd) Step No Yes Value(s) Action 10 1. Check for an open or short in the Alarmer and Relay Control Unit. 2. Check for an open of BLU/ORN wiring harness between Transmission Switches and Alarmer Relay Was a problem found? — Go to Step 11 Go to Step 12 11 1. Replace the Alarmer and Relay Control Unit. Or, between Alarmer and Relay Control Unit and PCM Is the action complete? Verify Repair — Go to Step 15 12 1. Ignition “OFF”. st or 4 th gear position. 4. Turn ignition “ON”, but don’t start the engine. Does the Upshift Lamp Stay “ON”? — Go to Step 13 Go to Step 15 13 Check for an short to ground of YEL/GRN wiring Was a problem found? — Go to Step 14 Go to Step 15 14 Repair for an open YEL/GRN wiring harness. Is the action complete? Verify Repair — — 15 Replace the PCM. IMPORTANT: The replacement PCM must be and also refer to latest service bulletin. Check to see if the Latest software is released or not. Is the action complete? — — — |