|
|
SE-38 AUTOMATIC DRIVE POSITIONER SELF-DIAGNOSIS RESULTS NOTE: ● All items count error detection frequency occurred after erase history to “1-127”. – If error was detected in the past, error detection frequency from memory erase to the present is displayed – If error has never been detected, nothing is displayed on “TIME”. – Can clear the detected memory. DATA MONITOR DTC Self-diagnosis item (CONSULT-II indication) DTC detection condition Reference page U1000 CAN COMM CIRCUIT When driver seat control unit is not transmitting or receiving CAN communication B2112 SEAT SLIDE When any manual and automatic operations are not performed, if any motor B2113 SEAT RECLINING When any manual and automatic operations are not performed, if any motor B2114 SEAT LIFTER FR When any manual and automatic operations are not performed, if any motor B2115 SEAT LIFTER RR When any manual and automatic operations are not performed, if any motor B2116 TILT OUTPUT When any manual and automatic operations are not performed, if any motor B2118 TILT SENSOR When tilt sensor detects 0.1V or lower, or 4.9V or higher, for 0.5 seconds or B2119 TELESCO SENSOR When telescopic sensor detects 0.1V or lower, or 4.9V or higher, for 0.5 seconds B2126 DETENT SW With the A/T selector lever in P position (Detente switch OFF), if the vehicle B2127 PARKING BRAKE With parking brake use (Parking brake switch ON), if a vehicle speed of 7km/h B2128 UART COMM Malfunction is detected in UART communication. Monitor item [OPERATION or UNIT] Contents SET SW “ON/OFF” ON/OFF status judged from the setting switch signal is displayed. MEMORY SW1 “ON/OFF” ON/OFF status judged from the seat memory switch 1 signal is displayed. MEMORY SW2 “ON/OFF” ON/OFF status judged from the seat memory switch 2 signal is displayed. SLIDE SW–FR “ON/OFF” ON/OFF status judged from the sliding switch (FR) signal is displayed. SLIDE SW–RR “ON/OFF” ON/OFF status judged from the sliding switch (RR) signal is displayed. RECLN SW–FR “ON/OFF” ON/OFF status judged from the reclining switch (FR) signal is displayed. RECLN SW–RR “ON/OFF” ON/OFF status judged from the reclining switch (RR) signal is displayed. LIFT FR SW–UP “ON/OFF” ON/OFF status judged from the FR lifter switch (UP) signal is displayed. LIFT FR SW–DN “ON/OFF” ON/OFF status judged from the FR lifter switch (DOWN) signal is displayed. |