|
|
BCM (BODY CONTROL MODULE) INL-81 < ECU DIAGNOSIS > C D E F G H I J K M A B INL N O P HIGH FLASHER OPERATION BCM detects the turn signal lamp circuit status by the current value. DTC Inspection Priority Chart INFOID:0000000003784935 If some DTCs are displayed at the same time, perform inspections one by one based on the following priority B2608: STARTER RELAY Inhibit engine cranking 500 ms after the following signal communication status becomes B2609: S/L STATUS • Inhibit engine cranking When the following steering lock conditions agree B260A: IGNITION RELAY Inhibit engine cranking 500 ms after the following conditions are fulfilled B260F: ENG STATE SIG LOST Maintains the power supply When any of the following conditions is fulfilled B2612: S/L STATUS • Inhibit engine cranking When any of the following conditions is fulfilled status recognized by the steering lock unit status signal (CAN B2617: STARTER RELAY CIRC Inhibit engine cranking 1 second after the starter motor relay control inside BCM becomes B2618: BCM Inhibit engine cranking 1 second after the ignition relay (IPDM E/R) control inside BCM be- B2619: BCM Inhibit engine cranking 1 second after the steering lock unit power supply output control in- B261E: VEHICLE TYPE Inhibit engine cranking BCM initialization B26E1: ENG STATE NO RECIV Inhibit engine cranking When any of the following conditions is fulfilled B26E9: S/L STATUS • Inhibit engine cranking When BCM transmits the LOCK request signal to steering lock unit, Display contents of CONSULT Fail-safe Cancellation Priority DTC 1 B2562: LOW VOLTAGE 2 • U1000: CAN COMM CIRCUIT 3 • B2190: NATS ANTENNA AMP |