|
|
*01 − − − − − − YES NO YES NO YES NO 14-137 PCM CONNECTOR C (44P) OP4SW 4TH CLUTCH OP4SW 11. Turn the ignition switch to LOCK (0). 12. Jump the SCS line with the HDS. 13. Disconnect PCM connector C (44P). 14. Check for continuity between PCM connector terminal C16 and 4th clutch transmission fluid Go to step 23. Repair an open in the wire between PCM connector terminal C16 and the 4th clutch 15. Replace the 4th clutch transmission fluid pressure switch (see page 14-207). 16. Reconnect all connectors. 17. Turn the ignition switch to ON (II). 18. Clear the DTC with HDS. 19. Start the engine, and warm it up to normal operating temperature (the radiator fan comes on). 20. Drive the vehicle in 4th gear in D for at least 2 seconds, then drive in 5th gear for at least 21. Check for Temporary DTCs or DTCs with the HDS. Check for poor connections or loose terminals at the 4th clutch transmission fluid If Temporary DTC or DTC P0873 is not indicated, or if any other Temporary DTCs are 22. Monitor the OBD STATUS for P0873 in the DTCs MENU with the HDS. Troubleshooting is complete. If any other Temporary DTC or DTCs were indicated on step 21, If the screen indicates FAILED, check for poor connections or loose terminals at the 4th clutch (cont’d) Wire side of Terminal side of Is ther e continuity? Is DT C P087 3 indicated? Does the scr een indicate PASSED? |