|
|
07 − − − 01 SJC8A00A20326400000FEAT00 Special Tools Required 11-288 11-288 Fuel Supply System Fuel Pressure Relieving (cont’d) Fuel Pressure Test A B C E D 07AAJ-S6MA150 07406-004000B 10. Disconnect the quick-connect fitting (A): Hold the connector (B) with one hand, and squeeze the NOTE: • Be careful not to damage the line (E) or other parts. • Do not use tools. tabs pressed down, and alternately pull and push • Do not remove the retainer from the line; once removed, the retainer must be replaced with a 11. After disconnecting the quick-connect fitting, check it for dirt or damage (see step 4 on page 11-293). 12. Reconnect the negative cable to the battery, then do this: • Power window control unit reset procedure (see page 22-209). • Enter the anti-theft codes for the audio system and the navigation system (if equipped). • Set the clock. • Fuel pressure gauge 07406-004000B 1. Relieve the fuel pressure (see page 11-286). 2. Disconnect the quick-connect fitting. Attach the fuel pressure gauge set and the fuel pressure gauge. 3. Start the engine, and let it idle. • If the engine starts, go to step 5. 4. Check to see if the fuel pump is running: listen to the fuel filler port with the fuel fill cap removed. • If the pump runs, go to step 5. troubleshooting (see page 11-282). 5. Read the fuel pressure gauge. The pressure should be 390 440 kPa (4.0 4.5 kgf/cm , 57 64 psi). • If the pressure is OK, the test is complete. fuel pressure regulator (see page 11-299) and the 2 |