FE06-0119b

1.

Remove  the  battery  negative  cable.  Refer  to

2.11.8.1

 

Battery Disconnection

.

2.

Lift and support the vehicle. Refer to

1.3

 

Lifting and Jacking

the Vehicle

.

3.

Remove  the  wheels.  Refer  to 

4.4.5.1

 

Wheel

Replacement

.

4.

Remove the tires.

5.

Remove the TPMS sensor.

Installation Procedure:

FE06-0120b

1.

Install the TPMS sensor.

Note

Make  sure  that  the  sealing  rubber  and  steel  ring
sensor are installed properly to ensure tires sealing.

2.

Install the tires.

3.

Carry out tires balancing detection and correction.

4.

Install the wheels.

5.

Lower the vehicle.

6.

Connect the battery negative cable.

Brake System

TPMS

6-113

6.7.8 Special Tools and Equipment
6.7.8.1 Trigger Tool

FE06-1007b

6-114

TPMS

Brake System

7 Steering System

7.1 Warnings and Notices.....................7-2

7.1.1 Warnings and Notices...........................................7-2

7.2 Hydraulic Power Steering System.....7-
3

7.2.1 Specifications...........................................7-3

7.2.1.1 Fastener Tightening Specifications....................7-3
7.2.1.2 General Specifications.......................................7-3

7.2.2 Description and Operation........................7-5

7.2.2.1 Description and Operation..................................7-5

7.2.3 System Working Principle.........................7-6

7.2.3.1 Hydraulic Power Rack and Pinion Steering Working
Principle..........................................................................7-6
7.2.3.2 Power Steering Pump Assembly Working Principle
7-8

7.2.4 Component Locator..................................7-9

7.2.4.1 Component Locator............................................7-9

7.2.5 Disassemble View..................................7-10

7.2.5.1 Disassemble View............................................7-10
7.2.5.2 Steering Disassemble View..............................7-11
7.2.5.3 Power Steering Pump Assembly Disassemble View
.....................................................................................7-12

7.2.6 Schematic...............................................7-13

7.2.6.1 Schematic.........................................................7-13

7.2.7 Diagnostic Information and Procedures.....7-
14

7.2.7.1 Diagnosis Description.......................................7-14
7.2.7.2 Visual Inspection..............................................7-14
7.2.7.3 Fault Symptom Table.......................................7-14

7.2.8 Removal and Installation........................7-18

7.2.8.1 Drive Belt Inspection........................................7-18
7.2.8.2 Power Steering Fluid Level Inspection.............7-18
7.2.8.3 Steering Fluid Pressure Inspection..................7-19
7.2.8.4 rower Steering Effort Check.............................7-21
7.2.8.5 Steering Tie Rod Ball Joint Inspection.............7-22
7.2.8.6 Power Steering Outlet Pipe Replacement........7-22
7.2.8.7 Power Steering System Bleeding.....................7-26
7.2.8.8 Check Power Steering Fluid.............................7-27

7.2.8.9 Power Steering Pipe Assembly with Fluid Reservoir
Replacement................................................................7-27
7.2.8.10 Power Steering Pump Assembly Replacement..7-
28
7.2.8.11 Steering Bar and Ball Joint Replacement.......7-30
7.2.8.12 Power Steering Dust Cover Replacement......7-32
7.2.8.13 Power Steering Gear Assembly Replacement...7-
33

7.3 Steering Wheel and Steering Column. .
7-38

7.3.1 Specifications.........................................7-38

7.3.1.1 Fastener Tightening Specifications..................7-38

7.3.2 Description and Operation......................7-39

7.3.2.1 Description and Operation................................7-39

7.3.3 Component Locator................................7-40

7.3.3.1 Component Locator..........................................7-40

7.3.4 Disassemble View..................................7-41

7.3.4.1 Disassemble View............................................7-41

7.3.5 Diagnostic Information and Procedures.....7-
42

7.3.5.1 Diagnosis Description.......................................7-42
7.3.5.2 Visual Inspection..............................................7-42
7.3.5.3 Fault Symptom Table.......................................7-42

7.3.6 Removal and Installation........................7-44

7.3.6.1 Steering Wheel Free Space Check..................7-44
7.3.6.2  Upper  and  Lower  Intermediate  Shaft  Universal
Joints Inspection...........................................................7-44
7.3.6.3 Steering Wheel Replacement...........................7-44
7.3.6.4 

Mechanical 

Steering 

Column 

Assembly

Replacement................................................................7-46

Steering System

Table of Contents

7-1

7.1 Warnings and Notices

7.1.1 Warnings and Notices

Anti-Corrosion Materials

Warning!

Notice: If the power steering system has been serviced,
an accurate fluid level reading cannot be obtained unless
air is bled from the steering system. The air in the fluid
may cause pump cavitation noise and may cause pump
damage over a period of time.

Power Steering Hose Disconnected

Warning!

Notice: Do not start the vehicle with any power steering
gear  inlet  or  outlet  hoses  disconnected.  When
disconnected, plug or cap all openings of components.
Failure to do so could result in contamination or loss of
power steering fluid and damage to the system.

Steering Wheel in the Full Turn Position

Warning!

Notice:  Do  not  hold  the  steering  wheel  in  the  full  turn
position longer than 5 s, as damage to the steering pump
may result.

Using Proper Power Steering Fluid

Warning!

Notice:  When  adding  fluid  or  making  a  complete  fluid
change,  always  use  DEXRON¢.  Failure  to  use  the
proper fluid will cause hose and seal damage and fluid
leaks.

7-2

Warnings and Notices

Steering System