Content .. 1 2 3 4 ..

Freightliner Century Class. Manual - part 3

Maintenance Operation 00–04

Lubrication and Fluid Level Check for Service Schedules I, II, III, and IV

Maint.

Operation

Number

Operation Description

Service

Schedules I, II,

and III (at M1)

Service

Schedule IV

(at M2)

Check

88–01

Hood Rear Support Lubrication

•

For Schedule II vehicles with Detroit axles, complete this procedure once a year or every 25,000 miles (40 000 km), whichever comes first.

†

Complete this procedure every 25,000 miles (40 225 km), 3 months, or 500 operating hours, whichever comes first.

General Information

Lubrication and Fluid Level Check: 00–04

00/9

tenance operations to be performed. All operations
listed in the table, along with the operations listed in
the applicable M1 maintenance interval table, must
be performed to complete the initial maintenance
(IM).

Maintenance

Operation Number

Check

00–06

Perform all M1 Operations

31–03

Frame Fastener Torque Check

31–05

Premier 690 Coupling Inspection

32–03

Suspension U-Bolt Torque Check

33–04

All-Axle Alignment Check

40–01

Wheel Nut and Rim Nut Check

47–03

Fuel Tank Band-Nut Tightening

General Information

00/10

Maintenance

Operation Number

Check

00–04

Lubrication and Fluid Level Check (includes the following):

• Eaton Fuller Clutch Release Bearing Lubrication
• Fifth Wheel Lubrication
• Trailer Electrical Connector Lubrication
• Suspension Lubrication
• Knuckle Pin Lubrication, Dana Spicer Axles
• Tie Rod Lubrication, Dana Spicer Axles
• Driveline Lubrication
• Dana Spicer Camshaft Bracket Lubrication
• Dana Spicer, Haldex, and Gunite Slack Adjuster Lubrication
• Cab Tilt Pump Reservoir Fluid Level and System Check
• Door Seal, Door Latch, and Door Hinge Lubrication
• Hood Rear Support Lubrication

13–01

Air Compressor Inspection

20–03

Fan Clutch Check (noise emission control)

31–01

Fifth Wheel Inspection

31–05

Premier 690 Coupling Inspection

40–02

Tire Check

41–01

Driveline Inspection