|
|
7. (D96) SIREN SIGNAL CONTROL CIRCUIT OPEN Disconnect the Intrusion Transceiver Module harness connector. Measure the resistance of the (D96) Siren Signal Control circuit Is the resistance below 5.0 ohms? Yes >> Replace the Intrusion Transceiver Module in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - CONTROL MODULES - STANDARD PROCEDURE) No >> Repair the (D96) Siren Signal Control circuit for an open. Perform BODY VERIFICATION TEST - 1A. (Refer to 8 - CONTROL MODULES - STANDARD PROCEDURE) PM VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS 8Q - 29 |