TEST
ACTION
APPLICABILITY
12
Turn the ignition off.
Disconnect the CAB harness connector C1.
Disconnect the Rear Wheel Speed Sensor harness connector.
Measure the resistance through the Rear Wheel Speed Sensor (+) and (-) circuits at
the CAB harness connector.
Is the resistance below 200 ohms?
All
Yes
→
Repair the Rear Wheel Speed Sensor Circuits Shorted together.
Perform ABS VERIFICATION TEST - VER 1.
No
→
Go To
13
13
If there are no possible causes remaining, view repair.
All
Repair
Replace the Rear Wheel Speed Sensor in accordance with the
Service Information.
Perform ABS VERIFICATION TEST - VER 1.
14
Turn the ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Refer to any Hotline letters or Technical Service Bulletins that may apply.
Were any problems found?
All
Yes
→
Repair as necessary.
Perform ABS VERIFICATION TEST - VER 1.
No
→
Test Complete.
47
BRAKES (CAB)
REAR SENSOR OPEN —
Continued